Digi M10 Technical overview and Guide d'installation télécharger pdf (Page 70)

Chapter 7: How to Proceed 65

5 Take the Master Compression Panel (included in the Side Covers package) and hold it so that the side with the springs faces the

back of the frame. If you have a Frame Chassis Small, use the smaller Master Compression Panel.

6 Holding the panel at an angle, place the spring side of the panel against the back of the chassis. Apply enough pressure to com-

press the springs, then lower the front edge and snap it into place.

Installing T Strips

After installing modules and Compression Panels, install T-strips to further secure the modules in their chassis.

To install T-Strips:

1 Collect all T-strips (one is included with each Frame Chassis kit and one is included with the Side Covers kit).

2 Take the first T-Strip and, orienting it as shown in Figure 39, do the following:

• Insert the bottom end (the end closest to the front of the control surface) into the receiving slot in the Side Wall.

• Working towards the back, push the T-strip down into its channel then push the end of the T-strip down so it clicks into place.

3 Repeat for all other T-strips.

If you need to remove T-strips, see “Removing Modules” on page 71.

Figure 38. Installing a Master section Compression Panel

Figure 39. Installing a T-strip

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 81 82

Pas de commentaire

Digi M10 Technical overview and Guide d'installation Page 70