Digi 9XCite-PKG Manuel Page 22
- Page / 39
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
9XCite‐PKG‐R™RS‐232/485RFModem–ProductManualv2.1[2007.01.04]
©2007MaxStream,Inc. 22
4.4. Automatic DIP Switch Configurations
Each time the RF Modem is powered-on, intelligence on the Max-
Stream Interface Board (located inside the RF Modem) sends AT
Commands that program the modem based on positions of the DIP
Switch. Automatic configurations that take place during the power-on
sequence affect RF Modem parameter values as shown below.
To avoid overwriting previously stored custom configurations (due to the automatic configurations
that take place each time the RF Modem is powered-on), it is necessary to disable a processor
located on the XIB-R interface board. To disable the processor, populate J7 of the XIB-R Interface
Board. (By default, J7 jumper is not populated.)
Table4‐03. RFModemPower‐upOptions(J7jumperandConfigSwitch)
ATCommandsSentasresultofDIPSwitchSettings(SW=DIPSwitch)
Condition Behavior
If J7 is populated Processor is disabled and AT Commands are not sent to the RF Modem
If Config Switch is pressed Processor is disabled and RF Modem enters into AT Command Mode
If J7 is NOT populated and Config
Switch is NOT pressed
Execute logic as shown in Table 6.
Condition Behavior
Serial Interfacing Options
If SW1 is ON (up)
AT Commands sent: ATCS 0 (RS-232 Operation: CTS
function for CTS line)
ATCD 2 (DO3 - RX LED = low)
If SW1 is OFF (down)
AT Commands sent: ATCS 3 (RS-485 or RS-422 Operation)
ATCD 2 (DO3 - RX LED = low)
Exit AT Command Mode
Always AT Commands sent: ATCN (Exit AT Command Mode)
- MaxStream 1
- Contents 3
- 1.9XCiteRS‐232/485RFModem 4
- 1.2. Specifications 5
- 1.3. External Interface 6
- 2.InterfacingProtocol 7
- 2.1.2. Wiring Diagrams 8
- 2.2.2. Wiring Diagram 9
- 2.3.2. Wiring Diagrams 10
- 3.RFModemOperation 12
- 3.2. Modes of Operation 13
- 3.2.3. Receive Mode 14
- 3.2.4. Sleep Modes 15
- 3.2.5. Command Mode 17
- 4.RFModemConfiguration 18
- 4.2. Configuration Software 19
- 4.3. Command Reference Tables 20
- 4.5. Command Descriptions 23
- 5.AdvancedNetworking 32
- 5.1.2. Channel (ATHP) 33
- Labeling Requirements 35
- FCC Notices 35
- Limited Modular Approval 36
- FCC-approved Antennas 36
- 1-Year Warranty 38
- Ordering Information 38
- Contact MaxStream 39
Produits connexes et manuels pour Modems à radiofréquence (RF) Digi 9XCite-PKG
(61 pages)AEG Electrolux L7147EXFL manuels
Manuels d'utilisation et guides de l'utilisateur pour Machines à laver AEG Electrolux L7147EXFL.
Nous fournissons des manuels en pdf 6 AEG Electrolux L7147EXFL à télécharger gratuitement par type de document : Manuel de l'utilisateur
Commentaires sur ces manuels