Digi DC-190 Manuel d'instructions télécharger pdf (Page 26)

Digitronic Digital Cam Switch Unit

Automationsanlagen GmbH CamCon DC190

4.10.1. The DC190 Status LED

The status LED of the CamCon shows the different blinking intervalls of the the device state. This way,

the operation state of the device can be seen without a PC or a terminal.

total time: 3.2 seconds

State

= "OK"

= "Clear..."

= "Pos.Error: 1"

= "Pos.Error: 2"

= "Pos.Error: 3"

= "Pos.Error: 5"

= "Output Error"

= "indicates an error in the EEPROM memory"

See also chapter "8. Error messages and removal of errors (FAQ)" on page 56.

5. Commissioning

Please check the device’s wiring before you switch it on. See also chapter "4. Electrical connections"

on page 14 for hints.

Attention: Inductive Reactances always have to be switched with a recovery diode!

Inductors or contactors that are mounted in proximity to the DC190 or the

wiring of which could affect the unit must be switched with RC elements.

The CamCon acknowledges the start-up with a flashing Status LED. After an internal

check-up, the system is booted (e.g. the EEPROM’s checksum is determined as is the Flash’s). This

procedure takes a few seconds.

The CamCon DC190 can be programmed via the EtherNet TCP/IP interface, the integrated Web

server DigiWEB or a Web-Browser like Internet Explorer or FireFox. It is therefore necessary to know

or set the unit’s correct IP-address.

5.1. Setting the IP-Address

Attention: Any IP – address must only be given once within a LAN. If you do not know any free IP,

please necessarily contact your network administrator before you connect the DC190 to

the network.

The factory setting of the device’s IP address is 192.168.3.128 / 255.255.255.0.

Should you decide to use another address, take down the MAC address of your CamCon (see type

plate) first (e.g. 00:50:C2:1E:21:6C).

Connect the CamCon with a CAT5 Ethernet Cable with a switch of your

LAN or connect it via a Cross – Over – Cable with the RJ45 Connector of

your PC’s network card. Now open a command prompt (e.g. by typing CMD

in the “Run” command line in Windows).

Now type the command

"ipconfig" in the command

prompt, to determine your computer’s IP and subnet

mask.

If no IP address or subnet mask is displayed here or

the IP is displayed as 0.0.0.0, a network connection is

not yet set or set incorrectly. Please contact your

network administrator if necessary.

In our example the IP-address is 192.168.2.41 while the subnet mask is shown as 255.255.255.0. That

would indicate that the DC190’s IP must be configured within the range of 192.168.2.1 to

192.168.2.254. It must, nevertheless, not be identical to the IP of the computer itself. You could use,

for example, the IP 192.168.2.128. or similar.

Version from: 19.04.2012 Page: 26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 63 64

Commentaires sur ces manuels

Pas de commentaire

Digi DC-190 Manuel d'instructions Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Balance de cuisine Digi DC-190