Digi LTS 32 Guide d'installation télécharger pdf (Page 56)

Syntax Configure autoconnect

set autoconnect

[port={range|xbee|internalmodem}]

[state={on|off}]

[trigger={always|data|dcd|dsr|string}]

[service={raw|rlogin|ssl|telnet|ssh}]

[description=string]

[ipaddress=ip address]

[ipport=ip port]

[connect on string=string]

[flush_string={on|off}]

[keepalive={on|off}]

[nodelay=on|off]

Display autoconnect settings

set autoconnect [port={range|xbee|internalmodem}]

Options port={range|xbee|internalmodem}

Used to specify the serial port. Optional on a single-port device.

To configure settings for the XBee port, specify “port=xbee.”And to

configure settings for an internal modem port, specify

“port=internalmodem.”

state={on|off}

Enables or disables the autoconnect feature.

Enables the autoconnect feature.

off

Disables the autoconnect feature.

The default is off.

If you are using the serial port for another purpose, it is recommended this

value be set to “off.”

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 190 191

Pas de commentaire

Digi LTS 32 Guide d'installation Page 56