Digi 9XCite-PKG Manuel télécharger pdf (Page 17)

9XCite‐PKG‐R™RS‐232/485RFModem–ProductManualv2.1[2007.01.04]

©2007MaxStream,Inc. 17

3.2.5. Command Mode

AT Command Mode provides access to AT-Settable parameters. These parameters extend flexibil-

ity in configuring modems to fit specific design criteria such as networking modems. Not all of the

parameters in the XCite Module can be adjusted using AT Commands.

AT Command Mode

To Enter AT Command Mode:

Default AT Command Mode Sequence (for transition to Command Mode):

• No characters sent for one second [refer to the BT (Guard Time Before) Command]

• Input three plus characters (“+++”) within one second

[refer to the CC (Command Sequence Character) Command.]

• No characters sent for one second [refer to the AT (Guard Time After) Command.]

All of the parameter values in the sequence can be modified to reflect user preferences.

To Send AT Commands:

Figure3‐07.SyntaxforsendingATCommands

To read a parameter value stored in the modem register, leave the parameter field blank.

The preceding example would change the modem’s Destination Address to "0x1F". To store the

new value to non-volatile (long term) memory, the Write (ATWR) command must subsequently be

sent before powering off the modem.

System Response. When a command is sent to the modem, the modem will parse and execute

the command. Upon successful execution of a command, the modem returns an “OK” message. If

execution of a command results in an error, the modem returns an “ERROR” message.

To Exit AT Command Mode:

For an example of programming the RF modem using AT Commands and descriptions of each config-

urable parameter, refer to the "RF Modem Configuration" chapter.

1. Send the 3-character command sequence "+++" and observe guard times before and after

the command characters. [refer to ‘Default AT Command Mode Sequence’ below.] The ‘Ter-

minal’ tab (or other serial communications software) of the X-CTU Software can be used to

enter the sequence.

[OR]

2. Assert (low) the CONFIG

pin and turn the power going to the RF modem off and back on. To

achieve this result, simultaneously press the Reset and Config switches [Figure 1-02];

release the Reset Switch; then after 1 second, release the Config Switch. The RF Modem

then enters AT Command Mode at the modem's default baud rate

Send AT commands and parameters using the syntax shown below.

1. If no valid AT Commands are received within the time specified by CT (Command Mode

Timeout) Command, the modem automatically returns to Idle Mode.

[OR]

2. Send ATCN (Exit Command Mode) Command.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 38 39

Pas de commentaire

Digi 9XCite-PKG Manuel Page 17