Digi PortServer TS 8 Guide de l'utilisateur télécharger pdf (Page 14)

14 Chapter 2 Configuring the IP Address

the boot command reboot the Digi device, which is required for the address

change to take affect.

set config ip=192.150.150.10 submask=255.255.255.0 dhcp=off

set config gateway=192.150.150.11

boot action=reset

Configuring an IP Address using DHCP and RARP

About DHCP and RARP

When the device server boots, it transmits a DHCP request and a RARP

request. This continues until an address is assigned.

Procedure

To use RARP or DHCP follow these steps:

1. Set up an entry for an address on a DHCP or RARP server. If you

intend to use RealPort, do the following:

• Reserve a permanent IP address.

• Record the IP address. You will need it when you configure the

RealPort driver.

2. Power on the device server.

The DHCP or RARP server assigns the device server an IP address.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 90 91

Pas de commentaire

Digi PortServer TS 8 Guide de l'utilisateur Page 14