Digi PortServer TS 8 Guide de l'utilisateur télécharger pdf (Page 15)

Configuring an IP Address using DHCP and RARP

Chapter 2 Configuring the IP Address 15

Example

set config submask=255.255.255.0

4. To configure a default gateway, enter the following command:

set config gateway=ip-address

where ip-address is the IP address of the default gateway

Example

set config gateway=191.143.2.46

5. Reboot the Digi device at the prompt using the following command:

boot action=reset

Manual Configuration Example

In this example set config commands configure the Ethernet interface and the boot command reboot the Digi

device, which is required for the address change to take affect.

set config ip=192.150.150.10 submask=255.255.255.0 dhcp=off

set config gateway=192.150.150.11

boot action=reset

Configuring an IP Address using DHCP and RARP

About DHCP and RARP

When the Digi One/PortServer TS 2/4 boots, it transmits a DHCP request and a RARP request. This continues

until an address is assigned.

Procedure

To use RARP or DHCP follow these steps:

1. Set up an entry for an address on a DHCP or RARP server. If you intend to use RealPort, do the following:

• Reserve a permanent IP address.

• Record the IP address. You will need it when you configure the RealPort driver.

2. Power on the Digi One/PortServer TS 2/4.

The DHCP or RARP server assigns the Digi One/PortServer TS 2/4 an IP address.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 99 100

Pas de commentaire

Digi PortServer TS 8 Guide de l'utilisateur Page 15