Digi PortServer TS 8 Guide de l'utilisateur télécharger pdf (Page 76)

In This Chapter

Chapter 17 Managing the OS and Configuration 76

Chapter 17 Managing the OS and Configuration

In This Chapter

Upgrading the Firmware................................................................................................................76

Copying the Configuration to and from a Remote Host................................................................77

Resetting the Configuration to Defaults ........................................................................................79

Upgrading the Firmware

This section describes how to upgrade the firmware, which can be done from the web interface using HTTP or

FTP.

Prerequisite Task

Note: When upgrading from a firmware release prior to82000716_B , thePOST code must be upgraded first. To

determine your current firmware release, issue the set config command. If you need to upgrade thePOST code

first, here is how you do it:

1. Download thePOST code from the Digi web site to a server running TFTP.

2. To load the newPOST code, issue the following command:

boot load-post=tftp-server-ip:filename

where tftp-server-ip is the IP address of the TFTP server and filename is thePOST file.

Example: boot load-post=143.21.10.5:82000679_C1

3. Reboot the Digi device.

When the Digi device reboots, it is ready for new firmware.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 99 100

Pas de commentaire

Digi PortServer TS 8 Guide de l'utilisateur Page 76