Digi PortServer TS 8 Manuel de service télécharger pdf (Page 15)

Page 6 Quick Start

Connect other terminals and peripherals to the PortServer

At this point you may wish to connect other devices (terminals, modems or printers) to the

PortServer. If you’d prefer to “play with it” a bit and add other peripherals later, skip this part

and go to the next section, Log in and Configure the PortServer on page 9.

Terminals

Attach terminals to the other ports as previously described, plugging the RJ-45 or RJ-11

connectors (from the terminals) into the appropriate sockets in the back of the PortServer. All of

the ports are equal, and you can configure any port for any device. Make sure the power is off on

the PortServer and the terminals!

Some terminals require hardware handshaking; most that do use Data Terminal Ready (DTR) for

hardware handshaking. Here is a wiring diagram for this method:

Terminal/Printer Cable with DTR Handshaking

RJ-45-8Pin DB-25 Male

Pin Pin

DSR

RTS

GND

TxD

RxD

CTS

DTR

RTS

CTS

GND

TxD

RxD

DTR

Signal

( = Cable Shield)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 126 127

Pas de commentaire

Digi PortServer TS 8 Manuel de service Page 15