Digi PortServer TS 8 Manuel de service télécharger pdf (Page 45)

Page 36 Command Reference

#> info tcp

Network statistics collected over last 129 minute(s).

tcpInSegs : 436 tcpInFast : 365

tcpInErrs : 0 tcpInCksErrs : 0

tcpInTcbErrs : 0 tcpInNotOkErrs : 2

tcpInDrpData : 0 tcpInDrpOwByte : 0

tcpInUrgBytes : 0 tcpInNotInSeq : 0

tcpOutSegs : 613 tcpOutResets : 0

tcpOutRetxmts : 0 tcpActiveOpens : 0

tcpPassiveOpen : 5 tcpAttemptFail : 0

tcpEstabResets : 0 tcpCurrEstab : 3

tcpRtoAlgorith : 0 tcpRtoMin : 0

tcpRtoMax : 0 tcpHolAllocErr : 0

tcpTmrAllocErr : 0 tcpBarSyn : 0

tcpBadReset : 0

#> info udp

Network statistics collected over last 129 minute(s).

udaInDatagrams : 52 udpInErrors : 0

udpInNameResp : 2 udpInAddrResp : 4

udpInKme : 0 udpInUnknown : 0

udpOutDatagram : 55 udpNoPorts : 1248

kill

Syntax: kill tty=tty_number [action=eewrite]

The kill command is used to clear or reset the port named in the tty_number parameter. The

phrase action=eewrite is an optional parameter that should only be used as a last resort, as

it rewrites that port's configuration with the factory default settings. If you experience problems

with a connection, first try closing the session, shutting the terminal off, etc., before using the

kill tty=tty_number action=eewrite command.

The kill command requires root privileges.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 126 127

Pas de commentaire

Digi PortServer TS 8 Manuel de service Page 45