Digi PortServer TS 8 Manuel de service télécharger pdf (Page 55)

Page 46 Command Reference

aixon=on|off

Use auxiliary flow control characters (defined by set keys xona= and set keys

xofa=) for output flow control. Default=off

altpin=on|off

Setting Altpin ON switches the function of the DSR and the DCD inputs on the

interface connector, so that DCD is available when using an 8-pin RJ-45 connector

instead of a 10-pin RJ-45 connector. (See RJ Connectors on page 103.)

Default=off

cts=on|off

Use (or do not use) CTS (Clear To Send) for output flow control. Default=off

dcd=on|off

Use (or do not use) DCD (Data Carrier Detect) for output flow control. Default=off

dsr=on|off

Use (or do not use) DSR (Data Set Ready) for output flow control. Default=off

dtr=on|off

Use (or do not use) DTR (Data Terminal Ready) for input flow control. Default=off

ixoff=on|off

When ON, use software flow control (typically XON/XOFF) for input data.

Default=on

ixon=on|off

When ON, use software flow control (typically XON/XOFF) for output data.

Default=on

range=startport#-endport#

Specify a range of ports to be modified. If not specified, the command will act on the

current port. It is important to specify the port or port range when logged into the

PortServer remotely.

ri=on|off

When ON, use Ring Indicator (RI) for output flow control. Default=off

rts=on|off

When ON, use RTS (Request To Send) for input flow control. Default=off

save=on|off

Save or do not save the changes to EEPROM.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 126 127

Pas de commentaire

Digi PortServer TS 8 Manuel de service Page 55