Digi Digi One EM Guide d'installation télécharger pdf (Page 118)

set service

118 Chapter 2 Command Descriptions

set service

Devices

supported

This command is supported in all Digi Connect Family devices.

Purpose Used to:

• Enable and disable network services.

• Change the network port on which a given service listens.

• Display the entire service table, or an entry in the service table.

Required

permissions

Permissions must be set to “set permissions s-service=read” to display

network service settings, and “set permissions s-services=rw” to display

and change network service settings.

Syntax Enable/disable network services or change network port for service

set service [range=range]

[state={on|off}]

[ipport=network_port]

[keepalive={on|off}]

[nodelay={on|off}]

Display service table or entries in the table

set service [range=range]

Options range=range

Used to specify the index of the network service to which the rest of the

command’s options apply.

active={on|off}

Used to enable or disable a given network service.

ipport=network port

Used to change the network port on which a given network service

listens.

keepalive={on|off}

Indicates whether or not TCP keepalives will be sent for specified range

of services. If set to on, keepalives will be sent, if it is off, keepalives will

not be sent.

Configurable TCP keepalive parameters, for example, how many

keepalives to send and when to send them are configured globally via the

"set network" command (see "set network" on page 84).

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 167 168

Pas de commentaire

Digi Digi One EM Guide d'installation Page 118