Digi Digi One EM Guide d'installation télécharger pdf (Page 20)

display

20 Chapter 2 Command Descriptions

nat

Displays Network Address Table (NAT) status information.

pppstats

Displays Point-to-Point Protocol (PPP) status information.

serial

Displays serial modem signals (DTR, RTS, CTS, DSR, DCD).

uptime

Displays amount of time since the device was booted.

version

Displays boot, POST and EOS firmware version information and Digi part

numbers for those items.

wlan

Displays typical wireless LAN (WLAN) parameters for wireless devices.

Example display device

See also The “display” command’s focus is on real-time information. In contrast, the

“info” command displays statistical information about a device over time,

while the “status” command displays the status of outgoing connections

(connections made by “connect,” “rlogin,” or “telnet” commands). For more

information, see these commands:

• "info" on page 25.

• "status" on page 147

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 167 168

Pas de commentaire

Digi Digi One EM Guide d'installation Page 20