Digi Digi One EM Guide d'installation télécharger pdf (Page 51)

set autoconnect

Chapter 2 Command Descriptions 51

set autoconnect

Devices

supported

This command is supported in all Digi Connect Family devices.

Purpose Used to establish an automatic connection (autoconnection) between the

serial port and a remote network destination, and to display current

autoconnect settings.

Required

permissions

To use this command, permissions must be set to one of the following:

• For a user to display autoconnect settings for the line on which they are

logged in: “set permissions s-autoconnect=r-self”

• For a user to display autoconnect settings for any line:

“set permissions s-autoconnect=read”

• For a user to display and set the autoconnect settings for the line on

which they are logged in: “set permissions s-autoconnect=rw-self”

• For a user to display autoconnect settings for any line, and set the

autoconnect settings for the line on which the user is logged in:

“set permissions s-autoconnect=w-self-r”

• For a user to display and set the autoconnect settings on any line:

“set permissions s-autoconnect=rw”

See "set permissions" on page 86 for details on setting user permissions

for commands.

Syntax Configure autoconnect

set autoconnect [port=range]

[state={on|off}]

[trigger={always|data|dcd|dsr}]

[service={raw|rlogin|ssl|telnet}]

[description={string}]

[ipaddress=ipaddress]

[ipport=ipport]

[connect_on_string=string]

[flush_string={on|off}]

[keepalive={on|off}]

[nodelay=on|off]

Display autoconnect settings

set autoconnect [port=range]

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 167 168

Pas de commentaire

Digi Digi One EM Guide d'installation Page 51