Digi Digi One EM Guide d'installation télécharger pdf (Page 85)

set network

Chapter 2 Command Descriptions 85

IP address, gateway address, and submask. The default is on.

autoip={on|off}

When enabled, the device attempts to use the Auto IP protocol to find an

IP address, gateway address, and submask. The default is on.

idle=10-86400

The amount of time, in seconds, to wait while not receiving TCP packets

before sending out a keepalive probe.

probe_count=5-30

The number of TCP keepalive probes (specially formatted TCP frames)

to send out before closing the TCP connection.

probe_interval=10-75

The amount of time, in seconds, to wait between sending TCP keepalive

probes.

garbage_byte={on|off}

The garbage byte affects the frame; that is, the garbage byte sends a

byte of data that has already been acknowledged by the other side. This

option is necessary to work with some vendors' TCP implementations.

override_dhcp={on|off}

Indicates that keepalive options given by DHCP should be ignored, and

the statically configured ones used instead.

Examples Manually set the device IP address

set network ip=10.0.0.1 gateway=255.255.255.0

submask=255.255.255.0 dhcp=off static=on autoip=off

Use DHCP to find an IP address, gateway address, and submask

set network static=off dhcp=on

Use DHCP or the Auto IP protocol to automatically configure network

settings

set network static=off dhcp=on autoip=on

Pas de commentaire

Digi Digi One EM Guide d'installation Page 85